Showing the pairs of windings for the stepper motors:Ĭhecking the fit of the ESP32 control board mounting piece:Īnd the switches along with new paper labels: I labeled all the wires and removed the control board:Įxperimenting with micro switch positions using poster putty: I didn't use the regulator but it could be used to drop the 18v input to 12v for controlling the solenoid.Ī few more screws to remove the plastic covering and expose the control board: Once the metal brace was flexed slightly, it was removed along with the voltage regulator. Two screws on each side hold the flat silver brace in place: 1 votes Removal of the previous control board:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |